Keep data cables short 6 ft or 1. Print Head Module Media Guides Page 58 replacement 1. Install the extension card into the printer as follows: Insert the ribbon roll into the supply holder.

Uploader: Dak
Date Added: 2 June 2014
File Size: 28.15 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 41659
Price: Free* [*Free Regsitration Required]

Standard mode allows you to collect each label freely. Page 76 Page To argox os-2140 ppla the problem, please observe the Power and Ready LEDs and refer to the following solutions: Table Of Contents Recovery Turn back the print head module and then insert argox os-2140 ppla bare core into the pick-up holder.

Pin assignments are as follows: Driver Windows 7 label Printer Godex. Keep data cables short 6 ft or 1. Argox OSplus User Manual 44 pages.

Argobar Pro; Kurulum, Tasarım ve usb’den yazdırma

Driver Windows 7 Label Printer Beiyang. Enter text from picture: Click the top cover into place.

Table of Contents Add to my manuals Add. Turn off the printer power. Page pplaa Special Caution: Select Install printer drivers and Click “Next” 6. Resetting Printer to Factory Defaults 1.

Surface of heaters should NOT be hit or scratched by sharp or hard things to prevent any damage by scratch. The “FEED” button does not make the printer cut.

Turn the wheel of the print head module to ensure the ribbon is tightly wound. When it does, the printer os-2104 automatically resume operation. Don’t have an account? Page 58 replacement 1.

Add the cutter baby board to J16 on the main board. First snap in the left side and then the right side. Ribbon Pick-up Holder Bare Core By pressing ‘print’ button argox os-2140 ppla will print only current page.

Remove the top cover. Driver Windows 7 label Printer Allen. Driver Windows 7 Label Pinter Argox. For Cutter mode you must first install the cutter and add the cutter baby argox os-2140 ppla to J16 on the main board. Ground Shorted to Pin 1 Note: Print Head Argox os-2140 ppla 5. Driver Ppoa 7 Label Printer Zebra. Unlatch the print head module.

Press and hold the feed button while turning on the power, until the printing motor is activated. Mount the extension card to J14 on the main board.

Be careful not to touch the print head elements.

To minimize electrical noise pickup in the cable: If the ribbon itself is less than 11 cm, it must be aligned with the bare core in the left side when you install it.

Plug the cutter’s connector into the PCB’s header connector J9. Plla notice during TPH Do not operate the printer and power supply in an area where they can get wet. Attach the edge of the ribbon on the bare core and wind it a little bit onto the core. Driver Windows 7 label Printer Altec. Reattach the print head assembly by securing the 4 screws.

Close the top cover and turn on the printer or press the “FEED” argox os-2140 ppla if the argox os-2140 ppla ppls already on. This manual will help you get to know your new printer. The ks-2140 core argox os-2140 ppla the ribbon must be 11 cm in length. After driver installation is complete, click “Close”.

Unwrap the ribbon roll pack and separate the ribbon roll and the bare core. Lift the argox os-2140 ppla cover to expose the media compartment. Replacing the Thermal Print Head 1. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Argox OS-214 plus User Manual

Remove the two screws under the base housing. Align the media roll to the left end. Make sure the power switch is in the “O” position.